Pin Conflicts
- When the Deneyap Camera is connected, do not make any external connections to the camera pins.
- While an SD card is inserted into the built-in SD card connector, external connections can be made to the SD card connector pins (D9, D13, D14, and D15) only via an SPI interface with the same pin configuration; apart from this, do not make any external connections to these pins.
- When using the built-in addressable RGB LED, do not make any external connections to the D12 pin.
- During code (firmware) upload, do not make any external connections to the TX (D2) and RX (D3) pins. After the upload process is completed, if these pins are not used for UART communication, external connections can be made.
- During code (firmware) upload, do not make any external connections to the D8 (BOOT) pin. After the upload process is completed, external connections can be made.
- If an external connection is provided via the I2C connector, external connections can be made to the D10 (SDA) and D11 (SCL) pins using an I2C interface with the same pin configuration; apart from this, do not make any external connections to these pins.
Mounting
When removing your board that is placed on a breadboard (protoboard) or a similar unit, make sure to hold it carefully from the edges as shown in the image to prevent damage to the USB port.