Skip to main content

​
Operating Modes

Operating ModeNom. ValueUnit
Modem Sleep (CPU active, Freq = 240 MHz, all RTC peripherals enabled)32mA
Modem Sleep (CPU active, Freq = 240 MHz, all RTC peripherals disabled)23mA
Modem Sleep (CPU idle, Freq = 240 MHz, all RTC peripherals enabled)28mA
Modem Sleep (CPU idle, Freq = 240 MHz, all RTC peripherals disabled)20mA
Modem Sleep (CPU active, Freq = 160 MHz, all RTC peripherals enabled)24mA
Modem Sleep (CPU active, Freq = 160 MHz, all RTC peripherals disabled)16mA
Modem Sleep (CPU idle, Freq = 160 MHz, all RTC peripherals enabled)21mA
Modem Sleep (CPU idle, Freq = 160 MHz, all RTC peripherals disabled)14mA
Modem Sleep (CPU active, Freq = 80 MHz, all RTC peripherals enabled)20mA
Modem Sleep (CPU active, Freq = 80 MHz, all RTC peripherals disabled)12mA
Modem Sleep (CPU idle, Freq = 80 MHz, all RTC peripherals enabled)18.4mA
Modem Sleep (CPU idle, Freq = 80 MHz, all RTC peripherals disabled)10.5mA
Light Sleep (Wi-Fi and SPI power off, all I/O pins high impedance)750µA
Deep Sleep (ULP active, ULP-FSM)170µA
Deep Sleep (ULP active, ULP-RISC-V)190µA
Deep Sleep (ULP periodically active, 1% duty cycle)22µA
Deep Sleep (RTC timer, RTC memory enabled)25µA
Deep Sleep (RTC timer)20µA
Power Off1µA
  • In measurements taken in Modem Sleep modes, power consumption may increase depending on flash access.
  • In measurements taken in Deep Sleep (ULP active) modes, while the ULP coprocessor is running, internal peripherals such as GPIO and I2C can continue their operational activities.

​
RF Communication Modes (Wi-Fi / BLE)

Communication ModePeak ValueUnit
Transmitter (802.11b, 20 MHz, 1 Mbps, POUT = +19.5 dBm)310mA
Transmitter (802.11g, 20 MHz, 54 Mbps, POUT = +15 dBm)220mA
Transmitter (802.11n, 20 MHz, MCS7, POUT = +13 dBm)200mA
Transmitter (802.11n, 40 MHz, MCS7, POUT = +13 dBm)160mA
Receiver (802.11b/g/n, 20 MHz)63mA
Receiver (802.11n, 40 MHz)68mA
  • All measurements were performed at an ambient temperature of 25 °C with a 3.3 V supply voltage. Measurements in transmitter mode were conducted with a 100% duty cycle.
  • During measurements in receiver mode, all peripherals were disabled and the CPU was idle.