Skip to main content

​
Pin Conflicts

  • When the Deneyap Camera is connected, do not make any external connections to the camera pins.
  • During code (Firmware) uploading, do not make any external connections to the TX (D2) and RX (D3) pins. After the upload process is complete, if you are not using these pins for UART communication, you can make external connections.
  • If an external connection is provided via the I2C connector, an external connection can be made to the D10 (SDA) and D11 (SCL) pins with an I2C interface having the same pin configuration; however, do not make any other external connections to these pins otherwise.

​
Assembly

When removing your board placed on a breadboard or similar unit, you must hold it carefully by the edges as shown in the image to avoid damaging the USB port.

​
Maximum Voltage in Analog Reading

All analog pins from A0 to A17 with 12-bit resolution (including A14 / D26 reserved for battery voltage measurement) can be used as input pins for analog signals. These pins give the maximum value of 4095 at a voltage of approximately 3.15 V. (The board pins are not 5V tolerant; voltages above 3.3V should not be applied).